Standing seam and metal panel roofing, roof repair and full replacement in Bybee. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Bybee.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
The layer you never see is what keeps water out on the ugly days. We do not thin it out to save a few dollars on a bid.
If two other people have caulked it and it still leaks, call us. Most stubborn leaks turn out to be flashing, a valley, or a fastener nobody thought to check.
A limb through the roof or panels peeled back overnight needs covering now, not next week. We get it dried in first so the inside of the house stops taking damage.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
We repair what the storm actually broke. If that is one slope, we do one slope, and we will not pad an estimate to make a claim look bigger.
Small repairs get the same crew and the same care as a full roof. Free estimate, a price in writing, and the work done before the next rain moves in.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
Reflective coatings keep a metal roof cooler in summer and seal up the small stuff before it turns into a leak.
Ice backs up at a cold eave and pushes water sideways under the roof. We clear it without gouging the panels or the shingles.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
Churches, shops, barns and small commercial buildings. We have roofed everything from a wood shed to a steeple.
Rotted fascia and sagging soffit let water and animals in behind the roof edge. We cut the bad wood out and put new in.
From a few tabs to a whole slope, we fix shingle roofs without pushing you toward a replacement you are not ready for.
Here is what working with us looks like in Bybee: you call, somebody comes out and measures, and you get a written estimate with the panel or the shingle spelled out on it. If you say go, we schedule you and we show up on that day.
The crew tarps the beds, keeps the yard picked up as they go, and runs a magnet over the drive before pulling out. Small things, but they are the ones Bybee homeowners still mention a year later.
Here is what Bybee homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
The questions that come up on just about every estimate we write.
No. Estimates are always free in Bybee. We come out, measure, look in the attic if we can get to it, and leave you a written price. Nobody will push you to sign anything that day, and the number does not expire in an hour.
Most Bybee houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
Sometimes. If the decking is sound and there is only one layer of shingles, a Bybee metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Any dry stretch works. We roof in Bybee year round, though we schedule shingle work for when it is warm enough for the strips to seal properly, and we watch the forecast so your house is never left open overnight.
For most Bybee homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
Often, yes. Plenty of the Bybee roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Real feedback from homeowners whose roofs we have worked on.
"Old slate roof and I was afraid nobody would touch it. They matched the pieces and now you cannot tell which ones are new."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"They found a leak two other roofers could not. Turned out to be the chimney flashing, not the roof at all. Fixed in one afternoon and it has been dry ever since."
Roofing Brothers also serves these towns near Bybee.